Forums/Z31P/z31-repairs-forums electronics/PowerSteeringPump

Imported from Z31Performance.com Forums{{#if:Spazzymcgee| — original post by Spazzymcgee}}{{#if:2018-11-22 14:07:41|, posted 2018-11-22 14:07:41}}{{#if:3| · 3 post{{#ifeq:3|1||s}}}}{{#if:/Z31performance_archive/forum/z31-repairs-forums/electronics/541680-powersteeringpump.html|
Local archive: view archived thread on dev.z31library.com}}

Spazzymcgee: (2018-11-22 14:07:41)

Both of my electrical cables on my power steering pressure switch at the pump have been severed.

What is the correct "connecting" wire to wire I need to follow?

Manual does not state and I can not remember for the life of me which colored wire goes to which.

I have one wire which is "yellow with a green stripe" and another which is "orange with red rings" off the pwrstrswitch, and the wires on the harness are "full green" and "full red" in color.

I am guessing yellow & green goes to full green and orange & red goes to full red?

Anyone?

Z_Karma: (2018-11-22 18:19:27)

I just checked my 2 cars that are here and 3 other power steering pumps only to find non of them have the switch. Â¯\_(ツ)_/Â¯

But, the FSM does show that the switch doesn't pull a signal to chassis ground at the pump, which indicates it's insulated, which means that polarity doesn't matter.

That being said, i'd match the colors anyway.

Spazzymcgee: (2018-11-23 04:04:53)

Tracking.

Thank you Z_Karma for following in - I did not want to over think this. Â¯\_o_0_/Â¯