Forums/Z31P/z31-performance-upgrade-forums engine-mechanical-aa/Bearings
Imported from Z31Performance.com Forums{{#if:shane vincent| — original post by shane vincent}}{{#if:2010-02-22 04:01:03|, posted 2010-02-22 04:01:03}}{{#if:4| · 4 post{{#ifeq:4|1||s}}}}{{#if:/Z31performance_archive/forum/z31-performance-upgrade-forums/engine-mechanical-aa/9638-bearings.html|
Local archive: view archived thread on dev.z31library.com}}
shane vincent: (2010-02-22 04:01:03)
So i asked over at Z31.com with no reply to my post so i figured id ask here.
Cant remember witch bearings to use for the dett rods in a 12v motor. I know its been speculated the 12v bearings are better and the journal sizes are the same but didnt the dett rods have a small hole in the bearing for the wrist pin oiling? if that were the case i guess i awnserd my own question. dett rod bearings in a 12v motor.
ZFast88Z: (2010-02-22 04:42:07)
VG30ET bearings in an VG build
shane vincent: (2010-02-22 05:35:56)
Thankyou very much and use the the z32 40ftlbs on the rods right.
SATAN: (2010-02-22 06:57:35)
Yes, whatever the torque specs are for those rods. I thought it was like 46ft/lbs, but if the manual says 40, then 40 it is.