Editing Forums/Z31P/z31-repairs-forums electronics/PowerSteeringPump

{{ForumImport
|op_user=Spazzymcgee
|op_date=2018-11-22 14:07:41
|post_count=3
|archive_url=/Z31performance_archive/forum/z31-repairs-forums/electronics/541680-powersteeringpump.html
}}

'''Spazzymcgee:''' <small>(2018-11-22 14:07:41)</small>

Both of my electrical cables on my power steering pressure switch at the pump have been severed.

What is the correct "connecting" wire to wire I need to follow?

Manual does not state and I can not remember for the life of me which colored wire goes to which.

I have one wire which is "yellow with a green stripe" and another which is "orange with red rings" off the pwrstrswitch, and the wires on the harness are "full green" and "full red" in color.

I am guessing yellow & green goes to full green and orange & red goes to full red?

Anyone?

----
'''Z_Karma:''' <small>(2018-11-22 18:19:27)</small>

I just checked my 2 cars that are here and 3 other power steering pumps only to find non of them have the switch. Â¯\_(ツ)_/Â¯

But, the FSM does show that the switch doesn't pull a signal to chassis ground at the pump, which indicates it's insulated, which means that polarity doesn't matter.

That being said, i'd match the colors anyway.

----
'''Spazzymcgee:''' <small>(2018-11-23 04:04:53)</small>

Tracking.

Thank you Z_Karma for following in - I did not want to over think this. Â¯\_o_0_/Â¯