Editing Forums/Z31P/z31-performance-upgrade-forums engine-mechanical-aa/Bearings

{{ForumImport
|op_user=shane vincent
|op_date=2010-02-22 04:01:03
|post_count=4
|archive_url=/Z31performance_archive/forum/z31-performance-upgrade-forums/engine-mechanical-aa/9638-bearings.html
}}

'''shane vincent:''' <small>(2010-02-22 04:01:03)</small>

So i asked over at Z31.com with no reply to my post so i figured id ask here.

Cant remember witch bearings to use for the dett rods in a 12v motor. I know its been speculated the 12v bearings are better and the journal sizes are the same but didnt the dett rods have a small hole in the bearing for the wrist pin oiling? if that were the case i guess i awnserd my own question. dett rod bearings in a 12v motor.

----
'''ZFast88Z:''' <small>(2010-02-22 04:42:07)</small>

VG30ET bearings in an VG build

----
'''shane vincent:''' <small>(2010-02-22 05:35:56)</small>

Thankyou very much and use the the z32 40ftlbs on the rods right.

----
'''SATAN:''' <small>(2010-02-22 06:57:35)</small>

{{Quote|user=|}}

Yes, whatever the torque specs are for those rods. I thought it was like 46ft/lbs, but if the manual says 40, then 40 it is.