Z31/SENSORS/coil php

Auto-imported article. This page was generated by the Z31 Library import pipeline from forum sources{{#if: | in category {{{category}}} | }}. The text was synthesized by an LLM and has not been hand-verified. Please correct errors and remove this banner once reviewed.

{{#if: | [[Category:Auto-imported — {{{category}}}]] | }}

Z31 Ignition Coil

The Z31 Ignition Coil is a high output ignition coil comparable to many performance coils. Replacing your Coil with an aftermarket coil will not increase any performance in your Z.

WARNING - Do this modification at your own risk. We Are not responsable for any issues of your own doing.

Testing the Ignition Coil

You can test your ignition coil by checking the resistance between the primary and secondary windings. Use a multimeter to measure the resistance across the terminals as shown below.

image: Ignition Coil Terminals

| Terminals | Expected Resistance | |---|---| | 1 – 2 | 1 Ω | | 1 – 3 | 10k Ω |

Note: If your coil readings are outside these ranges, the coil is internally bad and should be replaced.

Wiring the Ignition Coil

Please Refer to the chart below on how the ignition coil is wired

| Terminal | Function | |---|---| | Terminal 1 | Coil Ground | | Terminal 2 | Coil 12V+ | | Terminal 3 | Coil Output to Distributor |