Z31/Stuckthrottle php: Difference between revisions
m XenonzcarImporter moved page Sites/Xenonzcar/z31/Stuckthrottle php to Z31/Stuckthrottle php without leaving a redirect: Flatten Sites/ namespace; provenance preserved via ImportedFrom banner |
Inline image refs: rewrite to local archive; clean empty image artifacts |
||
| Line 1: | Line 1: | ||
{{ImportedFrom|site=Xenonzcar|title=Z31 Sticking Throttle|url= | {{ImportedFrom|site=Xenonzcar|title=Z31 Sticking Throttle|url=https://dev.z31library.com/xenonzcar_archive/z31/Stuckthrottle.php.html|archive=https://dev.z31library.com/xenonzcar_archive/z31/Stuckthrottle.php.html|fetched=2026-05-15}} | ||
== Z31 Sticking Throttle == | == Z31 Sticking Throttle == | ||
| Line 5: | Line 5: | ||
This is a common problem. At the exit of the throttle cable guide is a rubber boot intended to keep out dust and water while flexing with the cable. After years in the weather the rubber dry rots and becomes brittle. In these cases the boot breaks off and slides around on the cable. Under just the right combination of acceleration, braking, bouncing, turning, the boot slips forward enough to wrap around the throttle half pulley with the cable. The cable can't drop between the guides of the half pulley and instead rides on top holding the throttle open to 3000 or 4000 rpm. The fix is easy. Rip that sucker off of there and it doesn't happen again | This is a common problem. At the exit of the throttle cable guide is a rubber boot intended to keep out dust and water while flexing with the cable. After years in the weather the rubber dry rots and becomes brittle. In these cases the boot breaks off and slides around on the cable. Under just the right combination of acceleration, braking, bouncing, turning, the boot slips forward enough to wrap around the throttle half pulley with the cable. The cable can't drop between the guides of the half pulley and instead rides on top holding the throttle open to 3000 or 4000 rpm. The fix is easy. Rip that sucker off of there and it doesn't happen again | ||
 | ||
=== Sources Used === | === Sources Used === | ||
Revision as of 18:01, 16 May 2026
Auto-imported article. This page was generated by the Z31 Library import pipeline from forum sources{{#if: | in category {{{category}}} | }}. The text was synthesized by an LLM and has not been hand-verified. Please correct errors and remove this banner once reviewed.
{{#if: | [[Category:Auto-imported — {{{category}}}]] | }}
Z31 Sticking Throttle
This is a common problem. At the exit of the throttle cable guide is a rubber boot intended to keep out dust and water while flexing with the cable. After years in the weather the rubber dry rots and becomes brittle. In these cases the boot breaks off and slides around on the cable. Under just the right combination of acceleration, braking, bouncing, turning, the boot slips forward enough to wrap around the throttle half pulley with the cable. The cable can't drop between the guides of the half pulley and instead rides on top holding the throttle open to 3000 or 4000 rpm. The fix is easy. Rip that sucker off of there and it doesn't happen again
Sources Used
- Written by: Frank Zemaitis
- Image by: XenonXIII