Z31/IACwiring php: Difference between revisions
m XenonzcarImporter moved page Sites/Xenonzcar/z31/IACwiring php to Z31/IACwiring php without leaving a redirect: Flatten Sites/ namespace; provenance preserved via ImportedFrom banner |
Inline image refs: rewrite to local archive; clean empty image artifacts |
||
| Line 1: | Line 1: | ||
{{ImportedFrom|site=Xenonzcar|title=Z31 Idle Air Control Wiring for the NA to Turbo Swap|url= | {{ImportedFrom|site=Xenonzcar|title=Z31 Idle Air Control Wiring for the NA to Turbo Swap|url=https://dev.z31library.com/xenonzcar_archive/z31/IACwiring.php.html|archive=https://dev.z31library.com/xenonzcar_archive/z31/IACwiring.php.html|fetched=2026-05-15}} | ||
== Z31 Idle Air Control Wiring for the NA to Turbo Swap == | == Z31 Idle Air Control Wiring for the NA to Turbo Swap == | ||
| Line 26: | Line 26: | ||
=== Sources Used === | === Sources Used === | ||
[ | [https://dev.z31library.com/xenonzcar_archive/z31/z31fsm.php 1984-1988 Nissan 300ZX Factory Service Manual]- Written By: Hendrick301 | ||
[[Category:Imported from Xenonzcar]] | [[Category:Imported from Xenonzcar]] | ||
Revision as of 18:01, 16 May 2026
Auto-imported article. This page was generated by the Z31 Library import pipeline from forum sources{{#if: | in category {{{category}}} | }}. The text was synthesized by an LLM and has not been hand-verified. Please correct errors and remove this banner once reviewed.
{{#if: | [[Category:Auto-imported — {{{category}}}]] | }}
Z31 Idle Air Control Wiring for the NA to Turbo Swap
Ok for those of you who have done the N/A to Turbo Swap on your Z31, Here is how to wire the idle controls for proper operation.
Items needed
- 2 female spade connectors
- Razor knife
- Crimper or pliers
- Extra wire (if needed)
Process
- Locate the 4-pin connector on the N/A harness that went to the N/A idle controls (on the intake plenum, driver side).
- Remove the N/A connector by unhooking the wires inside the connector. Plug these wires into the new turbo connector (use a small pick to lift the tab and release each wire terminal).
- Only reconnect the two wires for the idle up solenoid.
- The other two wires (black and blue) are for the idle control device:
- Black wire: Connects to the "up and down |" pin
- Blue wire: Connects to the "side to side -" pin
Sources Used
1984-1988 Nissan 300ZX Factory Service Manual- Written By: Hendrick301