https://dev.z31library.com/index.php?action=history&feed=atom&title=Forums%2FZ31P%2Fz31-performance-upgrade-forums_engine-mechanical-aa%2FBearings 2026-08-15T22:34:01Z Revision history for this page on the wiki MediaWiki 1.43.8 https://dev.z31library.com/index.php?title=Forums/Z31P/z31-performance-upgrade-forums_engine-mechanical-aa/Bearings&diff=5377&oldid=prev 2026-05-15T05:13:05Z

<p>Forum archive import (z31performance)</p> <p><b>New page</b></p><div>{{ForumImport<br /> |op_user=shane vincent<br /> |op_date=2010-02-22 04:01:03<br /> |post_count=4<br /> |archive_url=/Z31performance_archive/forum/z31-performance-upgrade-forums/engine-mechanical-aa/9638-bearings.html<br /> }}<br /> <br /> &#039;&#039;&#039;shane vincent:&#039;&#039;&#039; &lt;small&gt;(2010-02-22 04:01:03)&lt;/small&gt;<br /> <br /> So i asked over at Z31.com with no reply to my post so i figured id ask here.<br /> <br /> Cant remember witch bearings to use for the dett rods in a 12v motor. I know its been speculated the 12v bearings are better and the journal sizes are the same but didnt the dett rods have a small hole in the bearing for the wrist pin oiling? if that were the case i guess i awnserd my own question. dett rod bearings in a 12v motor.<br /> <br /> ----<br /> &#039;&#039;&#039;ZFast88Z:&#039;&#039;&#039; &lt;small&gt;(2010-02-22 04:42:07)&lt;/small&gt;<br /> <br /> VG30ET bearings in an VG build<br /> <br /> ----<br /> &#039;&#039;&#039;shane vincent:&#039;&#039;&#039; &lt;small&gt;(2010-02-22 05:35:56)&lt;/small&gt;<br /> <br /> Thankyou very much and use the the z32 40ftlbs on the rods right.<br /> <br /> ----<br /> &#039;&#039;&#039;SATAN:&#039;&#039;&#039; &lt;small&gt;(2010-02-22 06:57:35)&lt;/small&gt;<br /> <br /> {{Quote|user=|}}<br /> <br /> Yes, whatever the torque specs are for those rods. I thought it was like 46ft/lbs, but if the manual says 40, then 40 it is.</div>

z31p_Shane vincent