z31p_Visco1: Forum archive import (z31performance)

2026-05-15T05:09:21Z

Forum archive import (z31performance)

New page

{{ForumImport
|op_user=visco1
|op_date=2014-04-26 17:08:29
|post_count=6
|archive_url=/Z31performance_archive/forum/z31-performance-upgrade-forums/driveline-aa/23677-clutch-pedal-spring.html
}}

'''visco1:''' (2014-04-26 17:08:29)

does the spring assist the pedal to depress or to return the pedal to the up position? My pedal randomly drops a couple inches, but easily returns up by pulling on it. Always shifts fine, and not losing fluid anywhere. I was about to replace the Clutch master cylinder and when I disconnect the pedal from the cylinder it drops to that lower position. So does that mean the CMC provides the return pressure? I'm lost so any help is appreciated

----
'''sir420:''' (2014-04-26 19:57:24)

The pressure plate returns the pedal to its original position. If your pedal drops like you described the master or slave is letting fluid bleed by.

----
'''i r teh noobz:''' (2014-04-27 16:01:43)

Hydraulic pressure returns the pedal to its resting position. If you aren't losing fluid or having shifting trouble, the master cylinder is likely bypassing internally.

----
'''visco1:''' (2014-04-27 18:13:05)

Thanks , I was assuming that was the case with a worn piston or seal since no leaks. It appears the spring does assist the pedal to the final up position but only after the MC /Hydraulics pushes it up past a certain point where the spring can engage it. That's my take on it

----
'''PulseCode:''' (2014-06-19 14:11:32)

I'm having the same problem with my clutch and would love to know what the RELIABLE options are for a good master cylinder. Thanks.

----
'''visco1:''' (2014-06-20 00:52:40)

I had the same issue a few months ago. No leaks/loss of fluid. I believe it maybe a seal in the MC leaking internal. Before I replaced the MC I adjusted the stroke on the MC with the push rod and it hasnt happened since. There is a limit to this adjustment. I increased the length of the rod by only a couple turns. My thought is the spring is getting weak and/or the hydraulic return maybe slower also. That said, cylinder is cheap but may not solve the problem.

Forums/Z31P/z31-performance-upgrade-forums driveline-aa/Clutch Pedal Spring - Revision history

z31p_Visco1: Forum archive import (z31performance)