Editing Forums/Z31P/z31-performance-upgrade-forums engine-mechanical-aa/Radiator Angle

{{ForumImport
|op_user=300zxturboftw
|op_date=2016-07-07 03:48:27
|post_count=7
|archive_url=/Z31performance_archive/forum/z31-performance-upgrade-forums/engine-mechanical-aa/531469-radiator-angle.html
}}

'''300zxturboftw:''' <small>(2016-07-07 03:48:27)</small>

So with the 3 core radiators it's a bit tougher to get 2.5" pipe over the radiator. Given that I've had to drop the radiator down about 1" from it's original position (45* to about 37* from ground). I'm assuming this won't drastically change things, I will just have to duct it better or should I even worry?

Here's what it looks like currently…will need to lower radiator another 1/2" or so. IMG957255.jpg IMG954917.jpg

----
'''nismo kid:''' <small>(2016-07-07 04:23:21)</small>

Well I run the exact radiator in stock location. I run a 3" diameter tube between the radiator & body. It took very minor modification. (removed the bracket for the factory fan shroud) Here's the best pics I could find of my setup( that I already uploaded). These was taken during the fabrication process. As long as the air is directed nicely to the radiator you'll be fine. I personally wouldn't worry too much about it.

[archived image: IMG_0292.jpg]

[archived image: IMG_0294.jpg]

----
'''nismo kid:''' <small>(2016-07-07 04:33:25)</small>

I just went out to the garage & took a current pic. The body/headlight bucket was not modified. As you can see there's still room even with the 3" diameter tubing. So If angle bothers you enough, this is another ave to consider.

[archived image: 20160706_232731.jpg]

----
'''300zxturboftw:''' <small>(2016-07-07 05:04:44)</small>

Looks good and seems like it would have been the right set up for me but my intercooler is actually same side. Although, now I'm ordering a 2.5" wiggins clamp for my turbo =)

----
'''nismo kid:''' <small>(2016-07-07 06:31:54)</small>

{{Quote|user=300zxturboftw|Looks good and seems like it would have been the right set up for me but my intercooler is actually same side. Although, now I'm ordering a 2.5" wiggins clamp for my turbo =)}}

Thanks. What I did will work on either side of the radiator. But I'd just run it how it currently sits. Wiggins are super nice. Good luck on the build[archived image: cool.png]

----
'''Axel kain:''' <small>(2016-07-08 02:53:02)</small>

I did 2.5in over the same rad, just ovaled the pipe a bit where the bumper upper support brace goes across is all.

----
'''88sinZ:''' <small>(2016-07-08 04:17:58)</small>

Those wire clamps though.....