Editing Forums/Z31P/z31-performance-upgrade-forums engine-management/Haltech wire harness

{{ForumImport
|op_user=300zxturboftw
|op_date=2019-02-23 15:22:36
|post_count=5
|archive_url=/Z31performance_archive/forum/z31-performance-upgrade-forums/engine-management/542514-haltech-wire-harness.html
}}

'''300zxturboftw:''' <small>(2019-02-23 15:22:36)</small>

So after Matt from nistune answered some questions he recommended I switch to a standalone. Thinking of grabbing a haltech 2500. Would love to find a male pin pigtail/connector that would match our ECU so I can just wire it up without cutting the original harness. Is anyone using a haltech and found an easy way?

----
'''Z_Karma:''' <small>(2019-02-24 18:14:32)</small>

Finding an inline variation of that vintage of a connector could be nearly impossible, but you could make your own by desoldering the connectors off of a donor ECU and soldering them to a perfboard, making your own break-out board.

A few years ago i did some disassembly of one and found that the FI connector was made by AMP, but the others i could not determine.

----
'''300zxturboftw:''' <small>(2019-03-03 20:17:22)</small>

I can just use something like this and jump 2 pigtails together I would assume?

[archived image: MFG_1956.JPG]

----
'''300zxturboftw:''' <small>(2019-03-03 20:50:31)</small>

This seems like an option too. Obviously would have to figure out what the pin sizes are.

[archived image: img1_med.jpg]

----
'''Z_Karma:''' <small>(2019-03-04 04:10:41)</small>

Yeah you could totally use jumpers into the Z31 harness plugs and then pot them in place, as long as like you said, pin diameter is correct and makes a good contact.