Editing Z31/digitaldashcolorchange php (section)

=== Cluster Removal ===

First,[remove the combo switches](Switchpodbulbs.php)on each side of the gauge cluster. While you are under the dashboard, it's recommended to also remove the two 10mm nuts holding the power supply unit to the dashboard and unplug the two connectors.

* Remove the 4 screws holding the digital cluster bezel in place, then carefully pull out the bezel.
* Remove the two screws (one on each side) securing the cluster into the dashboard.
* Disconnect the three wiring harness plugs located across the top of the cluster.
-
For better access, remove the steering wheel:
* Remove the column covers by taking out the 4 Phillips screws. Unclip the covers from the column.
* Disconnect the key light and steering wheel control harness if equipped.
* Pull the horn pad off (start from the top). This will reveal the 19mm nut securing the wheel to the column.
* Loosen the nut but do not remove it completely. Wiggle the wheel side-to-side or use a steering wheel puller with the 8mm x 1.25 threaded holes.
* Once loose, remove the nut and pull the steering wheel off completely.

* With the steering wheel removed, you can now carefully pull the digital cluster out of the dashboard. I pull the bottom out first and then slide it towrds me being careful not to scratch the cluster lense.

https://dev.z31library.com/xenonzcar_archive/z31/images/Digidashcolorchangecluster/DSC05090sm.png