Editing Z31/Frontsuspensionreconditioning php (section)

=== Strut Assembly Reconditioning ===

-
Once clean, give each component that will be reused, a fresh coat of paint.

* Since my springs, strut bearing and upper mounts are in good condition, I chose to reuse them. Eventually, however, the springs will be replaced with lowering springs.
* Once you know what you need, order replacement components. I chose to use Tokico's adjustable Illumina strut Cartridge part #BZ4005. They are five way adjustable and will give a smooth ride on the lower settings and a rock hard ride with them on the high setting.
-
I also only needed to order new dust boots to install as my strut bearings and upper mounts were still in good condition.

-
(Note: The adjustable suspension strut tube is larger in diameter 35mm vs 32mm than the non-adjustable tube. To install Tokico adjustable Illumina struts into a non-adjustable suspension model you will need to swap out the strut tubes Part #’s
[http://www.courtesyparts.com/betasite/strut-kit-front-suspensionrh-p-376353.html 54302-11P25]AND[http://www.courtesyparts.com/betasite/strut-kit-front-suspensionrh-p-376354.html 54302-11P26])