Editing Z31/hoodscoop php (section)

==== Action Needed ====

* First, start off by removing your hood. Have a helper hold the hood while removing the hood shock mounts. There are 2 styles: one is a bolt-on with a 10mm bolt on each mount; the other has a ball stud. To remove these, unclip the hood strut and pull off the ball stud. At this point, you can then remove the four (4) 12mm bolts at the hood-to-hood hinge.
* Next, set your hood on a level surface. Use a set of body/fender stands to hold it, as foam padding will prevent scratching the paint.
-
Now lay out your holes and cutting marks as shown below.

* Once cut, seal the bare metal with a brush-on primer to protect the hood from rust.
* Now mount the scoop to the hood.
* Install your hood back on your car. Installation is reverse of removal.