Editing Z31/clutchhydrepairs php (section)

== Bleeding Process ==

=== Items Needed ===

* DOT 3 Brake Fluid
* 10mm Box or Line Wrench
* DORMAN H380147 Rear Outer Brake Line (280ZX)
* A Friend

=== Process ===

* Top off the clutch master cylinder with DOT 3 brake fluid.
* Connect a clear hose to the bleeder nipple on the clutch dampener (if equipped), and submerge the other end in a container filled with brake fluid.
* Have your friend pump the clutch pedal several times and then hold it down.
* With the clutch pedal held, crack open the bleeder valve to release pressure and fluid.
* Close the bleeder valve.
* Repeat steps 3–5 until no more air bubbles are seen in the fluid exiting the hose.
* Once the dampener is bled, repeat the entire process at the slave cylinder bleeder valve.

Hope this helps with getting your Clutch feeling good on your Z31

=== Sources Used ===

[[Z31/z31fsm php|1984-1988 Nissan 300ZX Factory Service Manual]]
* Clutch slave cylinder Picture by -
[http://www.rockauto.com Rockauto.com] - 280zx brake hose Picture by -
[http://www.rockauto.com Rockauto.com]

[[Category:Imported from Xenonzcar]]