Editing Z31/IACwiring php (section)

== Z31 Idle Air Control Wiring for the NA to Turbo Swap ==

Ok for those of you who have done the N/A to Turbo Swap on your Z31, Here is how to wire the idle controls for proper operation.

==== Items needed ====

* 2 female spade connectors
* Razor knife
* Crimper or pliers
* Extra wire (if needed)

==== Process ====

-
Locate the 4-pin connector on the N/A harness that went to the N/A idle controls (on the intake plenum, driver side).

* Remove the N/A connector by unhooking the wires inside the connector. Plug these wires into the new turbo connector (use a small pick to lift the tab and release each wire terminal).
* Only reconnect the two wires for the idle up solenoid.
-
The other two wires (black and blue) are for the idle control device:
* Black wire: Connects to the "up and down |" pin
* Blue wire: Connects to the "side to side -" pin

=== Sources Used ===

[[Z31/z31fsm php|1984-1988 Nissan 300ZX Factory Service Manual]]
* Written By: Hendrick301

[[Category:Imported from Xenonzcar]]